TA Technix wishbone set front axle with PU bushings

consists of:
2 x TA Technix wishbones front axle both sides (without joint, with rubber bearing)
OEM-comparison number: 1H0 407 151

2 x TA Technix suspension joints front axle on both sides
OEM-comparison number: 357407365, 357407365A

1 set TA Technix PU bushings rear wishbone mount
OEM-comparison number: 191407181D, 191407181E, 357407181
replaces the standard rubber bearing
Fitting location: front – rear

1 set TA Technix PU bushings front inner wishbone mount
OEM-comparison number: 191407182, 357407182
replaces the standard rubber bearing / – metal bearing
Models with sheet steel wishbones

1 x TA Technix tie rod end front left axle
OEM-Vergleichsnummer: 191419811

1 x TA Technix tie rod end front axle right side
OEM-Vergleichsnummer: 191419812
—
2 x TA Technix coupling rods front axle both sides at stabilizer bar outside short
OEM-comparison number: 191 411 315 B, 191 411 315, 191 411 315 BS, 191 411 315 B S1

1 set TA Technix PU bushings assembly / – mounting kit for coupling rod / stabiliser bar support
between wishbone and stabiliser
Inner diameter: 10mm

1 set TA Technix PU bushings front axle – stabiliser outer / – mounting point on coupling rod
replaces the standard rubber bearing in the upper part of the coupling rod
for models with 18mm stabiliser

suitable for
VW Golf III incl. Variant type 1H
VW Vento type 1H incl. Syncro,
VW Golf III+IV convertible type 1E, 1H
not for VR6 models”